Skip to main content
GNS MikroTik logo

How GNS CARE managed service differs from traditional IT maintenance

GNS Engineering Team 2 min read

Managed service and maintenance are often treated as the same thing, but they start in different places: maintenance starts when you report a fault, while a managed service starts from readable device state. Here is the difference, point by point.

1. The trigger: your phone call vs a status change

Traditional maintenance is triggered by your call. Before it, the provider knows nothing about the state of the kit; after it, the time goes into recovery rather than prevention. A managed service is triggered by readable data: supported equipment exposes status, events and alerts that can be monitored continuously instead of waiting for a call.

2. Where the data comes from: a snapshot vs continuous monitoring

An on-site inspection is a snapshot: if it powers on and connects while the engineer is there, it passes. A managed service reads approved status and events through a supported management interface or API and configures alerts around the fields that are actually available. MikroTik, CCTV, door-access and intercom systems can differ substantially; the assessment sets out the readable scope rather than treating unavailable data as monitored.

3. The replacement decision: after failure vs by condition

Traditionally the decision to replace a drive is made after it fails, with interrupted recording, a stopped till or a door that will not open. Where a supported system exposes drive health or similar state, the managed service can follow the trend and arrange inspection or replacement while the equipment still works. The Complete tier includes the contractual 24-hour hardware replacement.

4. How you pay: per visit vs per supported endpoint

Break-fix is charged per visit: every call-out is an invoice, and more faults mean more invoices. A managed service is priced per confirmed supported endpoint, from HK$800 per month (Essential) and HK$2,000 per month (Complete). The contract, endpoint list and service scope are stated in the quotation.

5. Records and audit

In the traditional model the record is a job sheet: what happened and what was replaced, written by hand. A managed service records readable events, actions and a monthly report. Events that cannot be read by a system still follow the agreed support process.

Which one fits

If you have one router and one switch, and an hour of downtime does not affect trading, per-visit maintenance may be enough. When the same line carries Wi-Fi, CCTV, door access and intercom, and a break in any of them stops the business, the managed model's value is earlier discovery of observable problems plus a fixed follow-up process.

The service scope is on the GNS CARE page, and the monthly fee calculator gives an estimate.

Frequently asked questions

Is a managed service the same as insurance?

Not quite. Insurance pays afterwards; a managed service finds the problem beforehand and arranges the fix. Hardware can still fail, but the response is already scheduled rather than starting from the failure.

We already have an IT team. Do we still need this?

It covers continuous monitoring, updates and records at the device layer, and does not replace internal IT support for users and business systems. Many customers have internal IT handle day-to-day user issues while we look after the health and updates of the network, CCTV and door access hardware.

Does it replace the hardware warranty?

No. The warranty follows the manufacturer terms. The managed service covers monitoring, updates, configuration backup, event handling and the swap arrangement included in your tier, and we handle warranty claims on your behalf.

How is the monthly fee calculated?

Per device endpoint: gateways, switches, access points, cameras, recorders, door access and phones each carry a rate, with a floor of HK$800 per month for Essential and HK$2,000 for Complete. The final count is confirmed in a written quote after the free site survey.

Chat on WhatsAppEmail us